Safety features
31
Overheating protection
All the induction coils and cooling ele-
ments for the electronics are fitted with
an overheating protection mechanism.
Before the induction coils or cooling
elements get too hot, the overheating
protection mechanism cuts in in one of
the following ways:
– Any Booster function in operation will
be switched off.
– The set power level will be reduced.
– The cooking zone will switch off
automatically. will flash in the cook-
ing zone display.
– Further cooking zones switch off
automatically.
Switch off the affected cooking zone.
If the cooking zone is not switched off,
and will flash alternately in the
cooking zone display.
You can use the cooking zones again as
usual when the fault code has gone out.
The overheating protection mechanism
can be triggered by:
– heating up an empty pan.
– fat or oil being heated on a high
power level.
– insufficient ventilation to the under-
side of the hob.
– a hot cooking zone being switched
on after an interruption to the power
supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact Miele.
To Next Page
Loading...
Need help?
General
