Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
48
Preparing the worktop
Make the worktop cut-out as shown
in “Building-in dimensions” or as cal-
culated (see “Installing several Pro-
Line appliances”). Remember to
maintain the minimum safety dis-
tances (see “Safety distances”).
Wooden worktops
Seal any cut surfaces on the wood
worktops with a special varnish, silic-
one rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be heat-
resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
Position the spring clamps and the
spacer bars at the top edge of the
cut-out in the positions shown in the
illustrations.
Secure the spring clamps and
spacer bars with the 3.5x25 mm
wood screws supplied.
To Next Page
Loading...
Need help?
General
