Cleaning and care
57
Dismantle the dispensing unit into
three pieces: disconnect the Y-
shaped piece, the dispensing spouts
and the holder from one another.
Clean all parts thoroughly.
Clean the area surrounding the
central spout with a damp cloth.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
Make sure that all parts are tightly
connected to one another.
Reassemble the dispensing unit.
Press firmly to connect the
dispensing spouts correctly to the
holder.
Insert the dispensing unit in the
coffee machine and connect the milk
pipework.
Refit the stainless steel cover.
Close the appliance door.
Fit cover to central spout appears in the
display.
Confirm the message with OK.
Cleaning the cup rim sensor
The cup rim sensor is located
underneath the central spout.
Clean the cup rim sensor at least once
a week and more often if heavily soiled.
To Next Page
Loading...
Need help?
General
