Miele DA 3160 User Manual

Changing a halogen lamp
^
Pull out the deflector plate, and
remove the grease filter as described
earlier.
^
Switch off the fan and the lighting.
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease
particles from your fingers will
adhere to the surface and damage
it. Please follow the manufacturer’s
instructions.
^ Remove the charcoal filter if the
rangehood is being used in
recirculation mode.
,
Before any cleaning or
maintenance work, disconnect the
rangehood from the mains supply.
Ensure that
– it is switched off at the wall socket
and the plug is withdrawn, or
– the mains fuse is withdrawn, or
– the screw-out fuse is removed
(in countries where this is
applicable).
^ Push down the lighting unit slightly
via the opening in the safety panel.
^ The halogen lamp is now accessible
to be unscrewed anti-clockwise.
^ Replace it with a new halogen lamp
(specification: GU/GZ 10, 230 V,
50 W). Screw the lamp into the
socket and push it upwards.
Please follow the manufacturer's
instructions.
^
Replace the grease filter and, if being
used in recirculation mode, the
charcoal filter.
Cleaning and care
19

Miele DA 3160 Specifications

General

Intensive speed	Yes
Number of speeds	3
Type of extraction	Ducted
Maximum extraction power	550 m³/h
Housing material	Stainless steel
Bulb type	Halogen
Bulb power	50 W
Number of bulbs	2 bulb(s)
Power requirements	230/50

Weight and Dimensions

Depth	275 mm
Width	595 mm
Height	409 mm