Miele DA 3160 User Manual

^
Place the exhaust ducting on the fan
connection for the rangehood.
^
See "Connection for air extraction" for
further instructions on fitting the
ducting.
Set up for recirculation mode
If site conditions are not suitable for the
rangehood to be used with air
extraction, the appliance must be set
up for recirculation.
For this, a conversion kit DUU 151,
available from your Miele Chartered
Agent, or Miele is required.
^
The non-return flap is not needed for
the recirculation mode. Depending
on model, it may already be fitted.
Pull the non-return flap off the bracket
from vent connection.
You will also need a charcoal filter (see
“Technical data”).
^ Fit the conversion kit as described in
the installation instructions supplied
with the kit.
^
Make sure that the slats on the
exhaust grille are directed towards
the middle of the room, and not
towards the wall or the ceiling.
^
Fit the charcoal filter (see “Cleaning
and care”).
Electrical connection
Refer to the notes in “Electrical
connection” and “Warning and
Safety instructions” before
connecting to the electricity supply.
Installation
31
dai2700

Miele DA 3160 Specifications

General

Intensive speed	Yes
Number of speeds	3
Type of extraction	Ducted
Maximum extraction power	550 m³/h
Housing material	Stainless steel
Bulb type	Halogen
Bulb power	50 W
Number of bulbs	2 bulb(s)
Power requirements	230/50

Weight and Dimensions

Depth	275 mm
Width	595 mm
Height	409 mm