Installation
*INSTALLATION*
104
Electrical connection
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations.
Connection should be made via a
switched socket. This will make it easier
for service technicians should the
appliance need to be repaired. The
electrical socket must be easily
accessible after installation.
Danger of injury.
Miele cannot be held liable for
unauthorised installation,
maintenance and repair work as this
can be dangerous to users.
Miele cannot be held liable for
damage or injury caused by incorrect
installation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
If the plug is removed from the
connection cable or if the cable is
supplied without a plug, the
appliance must be connected to the
electrical supply by a suitably
qualified electrician.
If the switched socket is not
accessible after installation, or if the
appliance is to be hard-wired, an
additional means of disconnection
must be provided for all poles. When
switched off, there must be an all-
pole contact gap of at least 3mm in
the switch (including switch, fuses
and relays). Connection data is
shown on the data plate. It must
match the mains electrical supply.
After installation ensure that all
electrical components are shielded
and cannot be accessed by users.
Total power rating
See data plate
Connection data
The connection data is quoted on the
data plate. Please ensure these match
the household mains supply.
Replacing the mains connection
cable
If the mains cable needs to be replaced
it must be replaced with a special
connection cable, type H05VV-F (PVC-
insulated), available from your Miele
dealer.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
