You can now select the detergent
used. Available selections are:
Powder, Gel, "2 in 1" and "3 in 1"
tabs.
See "Settings J - Detergent".
Starting a program
^
Press the "Start" button.
The program begins and the "Start"
indicator lights.
Cancel a program only in the first
5 minutes. Otherwise important
program steps (e.g. the water
softening) could be interrupted.
The program can be locked. To use this
function, see "Settings J - Program
lock".
Time display
Before the program starts, the time
display shows the running time of the
selected program in hours and minutes.
During the running program the
remaining time shows in the time
display.
The running time for the same program
may vary depending on the intake
water temperature, load size and
soiling.
When a program is selected for the first
time, a time is shown which equals an
average program running time with
cold water.
The time values in the program guide
correspond to the program running
times with standard loads and
temperatures.
Each time a program is run, the
electronic adjusts the program running
time according to the water intake
temperature and load size.
The current time of day, the remaining
and end time of the program can be
displayed during the running program.
^
Press the d button.
^
To change back to the main menu
press d again.
Use
35
To Next Page
Loading...
Need help?
General
