,
P lease follow the installation
instructions carefully .
A ll electrical work should be carried
out only by a suitably q ualified and
competent person, in strict
accordance with national and local
safety regulations.
E nsure power is not supplied to the
appliance while installation work is
being carried out.
This dishwasher is supplied with a
mains cable and moulded plug ready
for connection to an a.c. single phase
supply , (230 -240 V 50 H z for NZ and
A ustralia) via a fused plug and suitable
switched socket which is easily
accessible after installation.
^ The voltage, rated load and fuse
rating are given on the data plate
located above the door. P lease
ensure that these match the
household mains supply .
F or ex tra safety it is advisable to install
a residual current device (R C D ), with a
trip current of 30 mA .
^
D o not connect via an ex tension lead.
,
If the connection cable is
damaged it must be replaced with a
complete connection box and cable
by a Miele approved service
technician only .
The wires in the mains lead are
coloured in accordance with the
following code:
G reen/y ellow = earth
B lue = neutral
B rown = live
If the colours of the wires in the mains
lead of this appliance do not
correspond with the coloured markings
identify ing the terminals of y our plug,
proceed as follows:
^ The wire which is coloured green and
y ellow must be connected to the
terminal in the plug which is marked
with the letter E or by the earth
sy mbol z or coloured green, or
green and y ellow.
^ The wire which is coloured blue must
be connected to the terminal in the
plug which is marked with the letter N
or coloured black.
^
The wire which is coloured brown
must be connected to the terminal in
the plug which is marked with the
letter A (A U S TR A L IA ).
W A R N IN G :
T H IS A P P L IA N C E
M U S T B E E A R T H E D
E lec tric al c o nnec tio n
71
To Next Page
Loading...
Need help?
General
