T h e M iele w aterp ro o f anti-leak
sy stem
P roviding y our dishwasher has been
installed correctly , the Miele waterproof
anti-leak sy stem will protect y ou from
water damage throughout its lifetime.
C o nnec tio n to th e w ater su p p ly
,
W ater in the dishwasher must
not be used as drinking water.
–
The dishwasher may be connected
to a cold or hot water supply , max .
60 ° C . W e would only recommend
connection to a hot water supply if it
is economical, e.g. a solar powered
supply . W hen connected to a hot
water supply all programme stages
which would otherwise be carried out
with cold water will be carried out
with hot water.
,
A hot water connection with
temperatures ex ceeding 60 ° C may
cause damage to the unit, impair
wash results and affect the product
guarantee.
–
The inlet hose is approx . 1.5 m long. A
1.5 metre long flex ible metal ex tension
hose, pressure tested to 14,000 kP a/
140 bar, is available as an optional
accessory if req uired.
–
A tap with a
3
/
4
" male thread must be
provided on site.
–
The dishwasher is constructed to
comply with A ustralian regulations,
and may be connected to a suitable
supply without an ex tra non-return
valve if national regulations allow this.
–
The water pressure (flow pressure at
the take-off point) must be between
30 and 1000 kP a (0.3 and 10 bar).
If the water pressure is too high, a
pressure reducer valve must be
fitted.
,
To avoid any damage to the
appliance, the dishwasher must only
be connected to a fully vented
plumbing sy stem.
! The inlet hose must no t be
shortened or damaged in any way
as it contains electrical components
(see illustration).
This appliance incorporates back
-
flow protection comply ing with
A S /NZ S 3500.1.2. No further
backflow protection req uired for
connection to the water supply .
P lu m b ing
72
To Next Page
Loading...
Need help?
General
