Frequently Asked Questions
102
Problem Possible cause and solution
The in-operation
indicator light is
flashing quickly.
At the end of the
program, the alarm tone
sounds and the display
shows the following
message:
Fault F 601: A fault has
occured, turn the appliance
off then back on again.
Restart the program. If the
fault occurs agian, contact
Miele Service.
There is a fault in the AutoDos.
Turn the dishwasher off and back on again.
Check whether the PowerDisk holder and the
PowerDisk have been installed correctly (see
“Automatic dispensing/AutoDos” under
“Detergent”).
Activate the AutoDos function and restart the
program.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating AutoDos in the Extra
options menu of a program and manually dispensing
the detergent via the detergent compartment.
If you wish to use AutoDos again, contact Miele
Service.
The in-operation
indicator light is
flashing quickly.
At the end of the
program, the alarm tone
sounds and the display
shows the following
message:
AutoDos maintenance
required. Please check
AutoDos system.
The dishwasher does
not turn off at the end
of the program.
The dishware may not
be clean because an
insufficient amount of
detergent was
dispensed.
The AutoDos function is
automatically
deactivated during the
program sequence.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDos function was automatically deactivated.
Turn the dishwasher off and back on again.
Multiple messages appear in the display.
Clean the fill channel of the AutoDos (see
“Cleaning the AutoDos” under “Detergent”).
Clean the lower spray arm (see “Cleaning the
spray arms” under “Cleaning and care”).
Select OK to confirm each message.
Activate the AutoDos function by confirming the
message AutoDos available using OK.
Start the program again.
The program duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.