Detergent
64
Inserting a PowerDisk
Turn on the dishwasher before you
replace the PowerDisk so that the
dishwasher recognizes it.
Only replace the PowerDisk when the
message PowerDisk empty. Deactivate
AutoDos with OK. appears.
Turn the AutoDos lid to and open
it.
The message AutoDos lid open will
appear on the display.
Remove the empty PowerDisk.
If the arrows in the PowerDisk holder
and in the viewing window are not
pointing toward each other, remove
the PowerDisk holder (see “Cleaning
the AutoDos” under “Cleaning and
care”).
Put the holder back into place so that
the arrows point toward each other
and the holder lies flat.
When doing this, only touch the
PowerDisk holder by the yellow tab in
the middle. Do not touch the side tab.
Insert the new PowerDisk and press it
evenly downward until it sits flush.
To Next Page
Need help?
General
