Before using for the first time
21
Displaying and setting the water
hardness
Switch the dishwasher off with the
button, if it is switched on.
Press the Start button in and whilst
holding it in switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
Press the button twice.
The indicator will flash rapidly twice
at intervals.
The value set for the water hardness is
shown as a figure after in the display
(see chart).
will start flashing in the display.
This is the factory default setting of
15°d.
Use the Start button to select the val‐
ue which equates to your water hard‐
ness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
