Programme options
55
Factory default
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings.
Switch the dishwasher off with the
button, if it is switched on.
Press the Start button in and whilst
holding it in switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
Press the button 19 times.
The indicator will flash once slowly
and then rapidly 9 times at intervals.
The flashing sequence in the display in‐
dicates whether a setting has been
changed from its factory default.
– : All settings are set to factory de‐
fault settings.
– : At least one setting has been
changed.
To reset the dishwasher to the factory
default settings, press the Start but‐
ton.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
