Before using for the first time
21
Displaying and setting the water
har
dness level
Switch the dishwasher off with the
butt
on if it is switched on.
P
ress the
Start butt
on in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the
Start
button pressed in for
at least four seconds until the
Start
indicator light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the Delay start button twice.
The indica
tor light will flash rapidly
twice at intervals.
The value which has been set for the
wat
er hardness is shown as a figure af‐
ter in the display (see chart).
will star
t flashing in the display.
This is the factory default setting of
0.2 mmol/l (1 °d - German scale).
Use the Start butt
on to select the val‐
ue which equates to your water hard‐
ness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.
To Next Page
Loading...
Need help?
General
