Programme options
63
Factory default settings
If you have altered any settings from
the fact
ory default, you can reset them
back to the factory default settings as
follows:
Switch the dishwasher off with the
butt
on, if it is switched on.
P
ress the
Start butt
on in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the
Start
button pressed in for
at least 4 seconds until the
Start indi‐
cat
or light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the button 19 times.
The indica
tor light will do 1 long
flash and 9 short flashes at intervals.
The flashing sequence in the display in‐
dicat
es whether a setting has been
changed from its factory default.
– : All setting
s are set to factory de‐
fault settings.
– : At least one setting has been
changed.
T
o reset the dishwasher to the factory
default settings, press the
Start but‐
t
on.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
