Before using for the first time
23
Adding salt
Important! Before filling the salt
reservoir for the first time, you must
fill it with approx. 2 litres of water to
enable the salt to dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
reservoir.
Remove the lower basket and un-
screw the salt reservoir cap.
Water or saline solution will run out
of the reservoir when the cap is re-
moved.
It should therefore only be removed
in order to refill the salt reservoir.
Fill the reservoir with approx. 2 litres
of water (first use only).
Place the funnel provided over the
salt reservoir and carefully fill with salt
until the reservoir is full. The salt
reservoir holds approx. 2kg of salt
depending on the brand used.
Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
Immediately after filling the salt reser-
voir, run the QuickPowerWash pro-
gramme with the Short option and
without any crockery in the dish-
washer to dissolve and remove any
traces of salt from the cabinet.