Some of the standard oven settings
(which are set at the factory) have an
alternative which you can select if
required.
See the chart over for a list of these
settings.
The factory default settings are
indicated by a star *.
Proceed as follows:
^
Turn the programme selector to the
Light H/v position.
^
Press the multi-function selector
gently.
"P I" will appear in the display.
You can make changes to settings ("P I"
to "P II").
To do this:
^
Turn the multi-function selector
clockwise until the required number
is shown in the display. Then press it
gently to confirm your selection.
"S" appears in the display to let you
know that this setting can be altered.
^
Turn the multi-function selector until
the required setting is shown in the
display. Then press it gently to
confirm your selection.
The change is then stored in memory.
"P" will appear in the display again
together with the number for the oven
setting.
You can make changes to further
settings as long as you have not turned
the multi-function selector back to the
"0" position.
The altered settings are retained
after a power cut.
Altering oven settings v
41
To Next Page
Loading...
Need help?
General