The appliance must not be operated
until it has been correctly installed in
its housing unit. Otherwise it poses
an electric shock hazard.
Important:
Do not fit insulation material inside
housing unit. This would hinder the
intake of air to the appliance.
Important:
Remove the protective cork spacers
from the sides of the oven before
installation.
Turn off the mains electricity supply
to the isolator.
^
Connect the mains cable to the
isolator.
^
Push the appliance into the oven
housing unit and align it.
^
Open the oven door and using two
screws secure it to the side walls of
the housing unit through the holes in
the oven trim.
^
Reconnect the power supply to the
isolator switch.
Installing the oven
81
To Next Page
Loading...
