Oven interior
The oven interior, back panel and roof liner are coated with
dark pyrolytic enamel which facilitates cleaning.
This is a particularly hard enamel with an extremely smooth
surface.
Because of its anti-stick properties most debris can be easily
removed with warm water and a little washing-up liquid
applied with a soft cloth. This should be done after each use.
Allow the oven to cool down before cleaning.
Danger of burning!
Never use hard brushes, hard sponges, wire wool pads*,
knives or any other abrasive materials or cleaning agents.
They can damage the enamel.
If using an oven spray, the manufacturer's instructions
must be followed.
Pyrolytic cleaning of the oven interior
Before starting a pyrolytic cleaning process please note the
following advice:
Remove any coarse soiling from the oven before you start.
Clean the interior glass door panel thoroughly. Otherwise
splashes on the door may burn on making them difficult to
remove.
There is a fibre-glass door seal around the oven cavity.
This seal is particularly sensitive and should not be cleaned
unless absolutely necessary. Rubbing the seal can damage
it.
Remove all accessories as well as the runners and any extra
accessories such as, for example, the baking carriage, or
telescopic runners from the oven interior before starting the
pyrolytic cleaning process. The high temperatures needed
for pyrolysis will damage the accessories and cause
irreparable damage to the baking carriage and runners.
Cleaning and care
56
To Next Page
Loading...
