Operation
54
Interrupting a cooking
programme in the
Microwavefunction
You can interrupt cooking when using
the Microwavefunction and pause
the cooking duration.
During cooking, the OKsensor lights up.
Select the OKsensor.
Cooking is interrupted and the cooking
duration is paused.
TheOKsensor lights up.
Select the OKsensor.
The cooking programme resumes and
the cooking duration continues to count
down.
Cancelling cooking
Touch the sensor for the selected
function or the sensor.
When Cancel process appears in the
display, confirm withOK.
The oven compartment heating and
lighting will then switch off. Any cooking
durations set will be deleted.
The main menu will appear.
Pre-heating the oven
The Boosterfunction is used to quickly
heat up the oven compartment in some
functions.
It is only necessary to pre-heat the oven
in a few instances.
Most dishes can be placed in a cold
oven. They will then make use of the
heat produced during the heating-up
phase.
For dark bread dough as well as beef
sirloin joints and fillets, pre-heat the
oven compartment when using the
Fan Plusfunction.
Booster
The Boosterfunction is used to quickly
pre-heat the oven compartment in
some functions.
This function is switched on as the
factory default setting for the following
functions (Other| Settings|
Booster| On):
– Fan Plus
– Auto Roast
If you set a temperature above 100°C
and the Boosterfunction is switched on, a
rapid heating-up phase heats the oven
compartment to the set temperature. The
grill element and ring heating element
come on together with the hot air fan.
Delicate items (e.g. sponge or
biscuits) will brown too quickly on the
top if the Boosterfunction is used.
Switch off the Boosterfunction for
these items.
Switching off Booster for a cooking
programme
Select the Booster| Offsetting before
selecting the desired function.
The Boosterfunction is switched off
during the heating-up phase. Only the
heating elements for the selected oven
function are used to pre-heat the oven
compartment.
If you then want to restart a cooking
programme with the Boosterfunction,
select the Booster| Onsetting to
switch the function on again.