Settings
45
Volume
A sequence of audible signals will
sound at the end of the program or if
there is a fault, provided that the audi-
ble signals have been activated.
Audible signals in the event of a fault
In the event of a fault, the alarm tone
will sound 4times at intervals with a
short pause between each set of tones.
The alarm tone that sounds when
there is a fault cannot be deacti-
vated.
Audible signals
The audible signals at the end of a pro-
gram will sound 4times at intervals with
a short pause between each signal.
The volume of the audible signals at the
end of the program can be set to one of
7different settings. If no volume is se-
lected, the audible signals are turned
off.
Keypad tone
An audible tone sounds each time a
sensor button outside of the touch dis-
play is pressed.
The volume for the keypad tone can be
set to one of 7different settings. If no
volume is selected, the keypad tone is
turned off (except the On/Offsensor
button).
Welcome melody
If you turn the dishwasher on or off, a
brief melody will sound.
You can turn the melody off.
Memory
When the Memoryfunction is switched
on, the most recently started program is
saved.
When you switch the dishwasher off
and back on again after the end of a
program, the last program started will
be selected. This may increase energy
consumption.
Refill indicators
If you only ever use combination deter-
gent products or automatic dispensing
using Miele PowerDisks (if available),
you can turn off the refill reminders for
reactivation salt and rinse aid if you
wish.
Please make sure that if you stop us-
ing combination detergents, you refill
the reactivation salt and rinse aid.
Turn the refill reminders back on.