en
19
Press the OK button to confirm your
selection.
The settings will be displayed for ap-
prox. three seconds.The robot vacuum
cleaner will now start to vacuum at the
same time each day.
The Timer indicator lights up to
show that the timer has been acti-
vated.
To alter the entries, proceed as de-
scribed previously.
Deactivating the timer
Press the Timer button on the remote
control briefly.
The Timer indicator will go out.
Activating the timer / displaying a set
start time
Press the Timer button on the remote
control briefly.
The Timer indicator lights up, the
set start time is shown briefly and the
robot vacuum cleaner will start vacuum-
ing at the set start time.
Deactivating the acoustic signals
The acoustic signals are activated as
standard. You can deactivate and then
reactivate them.
Press the OK button on the remote
control for at least three seconds.
OFF will appear briefly in the clock dis-
play.
Acoustic signals for fault messages
cannot be deactivated.
Reducing the maximum crossing
over height
The robot vacuum cleaner is set as
standard so that it can negotiate a
height of up to 3/4" (20 mm).
This allows it to vacuum carpets, cross
over thresholds, etc.
If you would like to reduce this height
(down to approx. 1/4" (6 mm)) in order
to protect chair or table legs, or lamps
for example, you can deactivate the
factory default setting.
Press the Base button on the remote
control for at least three seconds.
LO will appear in the clock display.
Press the Base button again for at least
three seconds if you want to reactivate
the maximum crossing over height of
3/4" (20 mm). HI will appear in the clock
display.
To Next Page
Loading...
Need help?
General
