Miele HS18 User Manual

19
Finishing vacuuming if vacuuming
started from somewhere in the room
The robot vacuum cleaner will return to
its starting point and switch into
standby after approx. 60seconds.
The robot vacuum cleaner will stand
still when there is low battery capacity.
You should then recharge it.
Vacuuming manually
You can use the direction buttons on
the remote control to vacuum a
particular area of the room.
 While the robot vacuum cleaner is
vacuuming, press and hold one of the
direction buttons.
The robot vacuum cleaner will turn in
the desired direction until you let go of
the direction button.
 Press and hold the + direction button.
The robot vacuum cleaner will travel in
the desired direction and continue to
vacuum.
 Press the  button on the remote
control or the  sensor on the
display.
The original vacuuming process will
continue running.
Interrupting vacuuming
 Press the  button on the remote
control or the  sensor on the
display.
The robot vacuum cleaner stops.
Press the button or the sensor again to
continue vacuuming.
If you lift the vacuum cleaner off the
floor during a pause and then place it
down somewhere else, rLOC will
appear in the display when you activate
it again. The robot vacuum will turn
around and compare its new location
with its saved map data.
If the data is compatible, the robot
vacuum cleaner will start cleaning and
not go over surfaces that have already
been cleaned.
If the data is not compatible the robot
vacuum cleaner will not move.
rLOC in the display can only be
cancelled by pressing the button or the
sensor several times.
Manual navigation (without
vacuuming)
You can use the direction buttons on
the remote control to direct the robot
vacuum cleaner to a specific area of the
room.

Miele HS18 Specifications

General

Brand	Miele
Model	HS18
Category	Vacuum Cleaner
Language	English