Miele PDR 514 - Connectivity; Pairing Instructions

Connectivity
45
Pairing instructions
Follow the steps below to connect the tumble dryer to your network.
Opening the Supervisor level
 Switch on the appliance by turning the rotary control from the position to any other po-
sition.
 Open the door of the tumble dryer.
 Press and hold the /sensor control while you close the door.
 Keep pressing the /sensor control until / flashes and then lights up per-
manently.
You are now in the Supervisor level.
Establishing the local network connection via WPS
 On the supervisor level, select using the or arrow buttons.
 Then select the internal communication module using the or arrow buttons.
 Confirm with the /sensor control.
 Restart the tumble dryer by turning the rotary control to the position.
 Switch the appliance on again by turning the rotary control from the position to any
other position.
 Press and hold the sensor control for 4seconds until appears on the display.
 Then press and hold the sensor control for 2seconds until appears on the display.
A timer will then start.
 Press the WPS button on your router within the specified time.
The network connection via WPS is being established.
The appliance is now successfully connected.
Establishing a temporary network connection via soft AP
The network connection via soft AP is only possible if the tumble dryer is not already con-
nected to a network.
 On the supervisor level, select using the or arrow buttons.
 Then select the internal communication module using the or arrow buttons.
 Confirm with the /sensor control.
 Restart the tumble dryer by turning the rotary control to the position.
 Switch the appliance on again by turning the rotary control from the position to any
other position.
 Press and hold the sensor control until appears briefly on the display.
A timer will then start. The tumble dryer now opens the soft AP for 10minutes.
 Establish the connection with the Device Connector in Miele MOVE.
Once a connection is established, dots flash in the word.
Then continue with the Device Connector in Miele MOVE.