Problem solving guide
43
Programme cancellation and error message
Problem Cause and remedy
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum drain height is 1m.
Water intake fault.
Open stopcock.
The water inlet is blocked or restricted.
Check whether the stopcock has been properly
opened.
Check whether the inlet hose is kinked.
The water pressure is too low.
Switch on the Low water pressuresetting (see “Low
water pressure” under “Supervisor level”).
The filters in the water inlet are blocked.
Clean the filters (see “Cleaning the filters” under
“Cleaning and care”).
Waterproof system
activated
The water protection system has reacted.
Close the stopcock.
Call Miele Service.
Fault F . If restart
fails, call Service
There is a fault.
Disconnect the washing machine from the electri-
city supply.
Wait at least 2minutes before reconnecting the
washing machine to the electricity supply.
Switch the washing machine on again.
Start the programme again.
If the fault message appears again, contact Miele
Service.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
