Supervisor level
71
Anti-crease
The Anti-crease function reduces
creasing after the end of the pro-
gramme.
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes. The washing machine door
can be opened at any time.
Factory default: On
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a pro-
gramme with a temperature of 70°C or
higher is selected.
Suds cooling should be activated:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- Where the drainage pipes do not
comply with DIN1986.
Factory default: On
"Display" switch-off status
To save energy, the display goes out
and the Start/Stopbutton flashes
slowly.
Changing this setting leads to increased
energy consumption.
- Off
The display will remain on.
- On after 10min, not in current pro-
gramme (factory default)
The display will remain on while the
programme is running but will go out
10minutes after the end of the pro-
gramme.
- On after 30min, not in current pro-
gramme
The display will remain on while the
programme is running but will go out
30minutes after the end of the pro-
gramme.
- On after 10min
The display will go out after
10minutes.
- On after 30min
The display will go out after
30minutes.