When to change the thread
lifters
The thread lifters on the suction inlet of
the floorhead can be replaced.
Check them from time to time if the pile
has worn down.
Replacing the thread lifters
Your vacuum cleaner is supplied with
one of the following floorheads,
depending on model:
Floorhead SBD 350-3
^ Insert a knife or similar object into the
red indentations on the side of the
slots a and lever out the thread
lifters.
^ Fit new thread lifters b.
Floorhead SBD 450-3
^
Use a knife or similar object to
remove the thread lifters from the
slots. There are two grooves to help
you.
^
Fit new thread lifters.
Spare parts are available to order from
your Miele dealer, the Miele Spare Parts
Department (see back cover for contact
details), or via the internet at
www.miele-shop.com.
Maintenance and care
20
To Next Page
Loading...
Need help?
General
Weight and Dimensions
