Safety features
33
Safety switch-off
Sensor controls are covered
Your SmartLine element will turn off
automatically if one or several of the
sensor controls remain covered for
longer than 10 seconds, for example,
by finger contact, food boiling over or
by an object such as an oven glove or
tea towel. flashes briefly above the
sensor control and a tone will sound.
If you remove the obstruction and/or
clean the appliance, goes out and the
SmartLine element is ready for use
again.
Excessive operating time
The safety shut-off is triggered auto-
matically if the wok basin has been
heated for an unusually long period of
time. This time depends on the power
level selected. If it has been exceeded,
the wok basin turns off and the residual
heat indicator appears. The wok can
now be used again as normal.
The SmartLine element is pro-
grammed to safety setting 0 at the
factory. If required you can set a
higher safety setting with a shorter
maximum operating time (see chart).
Power level* Maximum operating time
[h:min]
Safety setting
0** 1 2
1 10:00 8:00 5:00
1. 10:00 7:00 4:00
2/2. 5:00 4:00 3:00
3/3. 5:00 3:30 2:00
4/4. 4:00 2:00 1:30
5/5. 4:00 1:30 1:00
6/6. 4:00 1:00 0:30
7/7. 4:00 0:42 0:24
8 4:00 0:30 0:20
8. 4:00 0:30 0:18
9 1:00 0:24 0:10
* The power levels with a dot after the num-
ber are only available if the power level
range has been extended (see “Setting
range”).
** Factory default setting
To Next Page
Loading...
Need help?
General
