Miele T 8929 WP User Manual

Problem solving guide
With the help of the following notes, minor faults in the performance of the
machine, some of which may result from incorrect operation, can be put right
without contacting Miele. A call-out charge will be applied for unnecessary service
visits where the problem could have been rectified as described in these
Operating instructions. Please note:
,
Repairs to electrical appliances should only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. Repairs and other work by unqualified persons
could be dangerous. The manufacturer cannot be held liable for unauthorised
work.
Fault messages in the display
Problem Possible cause Remedy
You are asked to enter a
code.
Access via a code has
been activated.
Enter the code (see
"Settings menu").
1
Adjust the load
The programme is
cancelled and the
buzzer sounds.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
Use the Warm air
programme to dry
individual items.
– Open and close the
door.
2
Empty the container
The programme is
cancelled and the
buzzer sounds.
The condensed water
container is full or there is
a kink in the drain hose.
–
Empty out the
condensed water
container or check the
drain hose.
To clear the display:
–
Switch the dryer off
and then on again.
Problem solving guide
39

Miele T 8929 WP Specifications

General

Brand	Miele
Model	T 8929 WP
Category	Dryer
Language	English