Programmable functions
76
PIN Code
The code prevents your machine
being used without your knowledge.
When the code has been activated, you
have to enter the code after switching
the dryer on. Otherwise the dryer
cannot be operated.
Options
= Off (factory setting)
= On
If option has been selected, after
switching on you will have to enter the
code before you can operate the dryer.
Using the dryer when the code is
activated
After the dryer is switched on, will
flash in the time display.
The code is and cannot be altered.
Touch the sensor until a flashes
in the first position.
Confirm with the Start/Add laundry
sensor.
Enter the two other numbers in the
same way.
The dryer is ready for use after has
been entered and confirmed.
Conductivity
This programmable function should
only be altered if the water is so soft
that it is likely to cause the electronics
which sense residual moisture in the
laundry to give false readings.
Options
= Off (factory setting)
= low
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) of less than 150 μS/cm. To
find out the conductivity level of your
mains water, contact your local water
authority.
Make sure that you only activate
for the condition described above.
Otherwise, drying results can be
unsatisfactory.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
