Changing the programme sequence
38
Changing a programme
After the successful start of a pro-
gramme it is no longer possible to
change the programme.
If you would like to change the pro-
gramme, you have to cancel the pro-
gramme.
Cancelling a programme
You can cancel a wash programme at
any time after it has started.
Touch and hold the Start/Stop sensor
until the time display switches to
:.
The water will be pumped away. As
soon as the symbol in the control
panel goes out, the programme has
been cancelled.
Open the door.
Selecting a different programme after
cancelling the programme
Close the door.
Check that there is still detergent in
the dispenser drawer. Add more de-
tergent if necessary.
Turn the programme selector to the
programme you want and start it by
pressing the Start/Stop sensor.
Removing laundry after cancelling
the programme
If you want to remove the laundry when
it is dripping wet:
Open the door.
Remove the laundry.
If you want to remove the laundry after
it has been spun (damp):
Open the door.
Close the door.
Turn the programme selector to
Drain/Spin.
Tip: Select an appropriate spin speed.
Interrupting a programme
Turn the programme selector to the
position.
The washing machine switches off.
To continue: turn the programme se-
lector to the position of the wash pro-
gramme that was started.
Tip: If appears in the time display,
the programme selector is in the incor-
rect position.
To Next Page
Loading...
Need help?
General