Miele WDB 030 WCS W1 Classic User Manual

Problem solving guide
49
The programme is cancelled and a fault indicator light lights up
in the control panel
Problem Cause and remedy
The fault indicator light
 lights up,  and  ap-
pear alternately in the
time display and the
buzzer sounds.
The water inlet is blocked or restricted.
 Check whether the stopcock is opened properly.
 Check whether the inlet hose is kinked.
 Check whether the water pressure is too low.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator light
 lights up,  and  ap-
pear alternately in the
time display and the
buzzer sounds.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum delivery head is 1 m.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water protection system has reacted.
 Close the stopcock.
 Call the Service Department.
 and  alternately
appear in the time dis-
play and the buzzer
sounds.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching off at the wall
socket and withdrawing the plug, or by discon-
necting the relevant fuse on the mains fuse board.
 Wait at least 2 minutes, before reconnecting the
washing machine to the mains electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact the
Service Department.

Miele WDB 030 WCS W1 Classic Specifications

General

Brand	Miele
Model	WDB 030 WCS W1 Classic
Category	Washer
Language	English