Mikado VBar NEO Quick Start Guide

1. Items needed for rst installation
On rst installation, you will need:
• VBar NEO with an external VBar Control Satellite
and a VBar Control radio, or a radio system with a
digital or bus output-receiver or Spektrum satelli-
tes. Analog receiver output (standard hookup with
patch wires, analog single-line PPM like Jeti (old),
HoTT SUM(O), RASST) are not supported.
• For updates and extensions, and to set up VBar
NEO using a computer, you need the VBar Control
Manager and the PC Software for VBar NEO which
you can download conveniently from www.vstabi.
info in one single software download.
• To perform updates, you need a Boot Plug
(connects to the Sensor connector at the time
of updating only).
• To use the VBar Control Manager and the PC
software, you need a Windows PC or a Macintosh
computer with access to the world wide web (for
Registration, Updates, Downloads, but not for the
actual setup) and a Mini USB wire to connect.
• Power supply (BEC or receiver battery).
• Helicopter with servos installed, but not yet
connected! Only digital servos allowed!
• Pitch Gauge (swash plate levelling tool).

Mikado VBar NEO Specifications

General

Brand	Mikado
Model	VBar NEO
Category	Remote Control
Language	English