6. Initial Programming
After you have clicked on the program icon, your screen will
show the main page with the parameter settings.
Now connect the VBar (rst time with servos still disconnec-
ted!) via the USB cable with the PC and with your power supply
(3.5 V to 8.4 V, e.g. to ESC or AUX2/3). VBar will start ashing
blue. The USB connectivity status display will switch to green,
and the connection status will also switch to green, indicating
“connected”. Now the screen will switch to initialization mode.
Do not move the model until VBar has completed initialization.
On successful initialization, the main page will reappear on
the screen, the LED will turn solid green or ash red/green (if
no receiver is congured yet).
You might be required to download a Key File rst (see above).
Now click on the Setup button to switch to the Setup Wizard,
which is your programming assistant. You will be led through
the setup menu step by step. After completion of the 13 steps,
your helicopter will be ready for ight. At each step you will
nd information on the left-hand side of the screen. Be sure
to read the text and follow the instructions! It is necessary that
you perform the steps in the order provided. Do not skip back
and forth between steps.
Attention: once you have set up your heli for the rst time, you
can navigate the Wizard using the Continue and Back buttons.
Don‘t click Create new setup unless you really need to, and
mind the safety instructions concerning speed controllers
and accidental spooling up!
To Next Page
Loading...
Need help?
General
