Safety Instructions
An R/C controlled helicopter is not a toy! While moving,
the rotor blades pose a serious danger to persons and things.
You must obey all safety instructions of the manufacturer for
operation of your helicopter.
VBar is not an autopilot! VBar may be installed in model
helicopters which are suitable for ying without ybar. During
installation and operation you must follow all instructions given
in the software and in this manual. VBar may not be operated
in wet conditions (high humidity or rain). If the helicopter shows
vibrating behavior during ight, operation of the helicopter is to
be stopped immediately. Do not continue ying until the cause
for vibration has been eliminated.
• Since the ESC is connected directly to the VBar,
disconnect the motor wires or remove the pinion gear
to avoid accidental spooling up of the helicopter while
setting up the speed controller (ESC) functions. The
same applies when loading unknown setup or preset-
les, as they may transport other receiver and speed
controller settings as you have on your heli!
• The external gyro sensor (set with sensor included)
must not be connected to a different connector than
Sensor, else it will be destroyed beyond repair imme-
diately.
• Make sure you use a sufcient power supply.
• Set and check fail safe. Refer to the manual of your ra-
dio. The motor must turn off when the radio is switched
off or when the receiver is disconnected from the VBar.
To Next Page
Loading...
Need help?
General
