1.
2.
3.
1.
2.
3.
Attach rack ears to both sides of the device and tighten four screws to secure them in place, as shown in the picture.
Place the device in a rackmount enclosure and align with the holes so that the device fits conveniently.
Tighten screws to secure it in place.
The device has no protection from water contamination, please ensure the placement of the device in a dry and ventilated environment.
We recommend
shielded Cat5/6 cables for our devices. Mounting and configuration of this device should be done by a qualified person.
Powering
The device accepts powering in the following ways:
Dual power supplies for redundancy, 110-240 V AC two inputs, IEC connectors.
PoE input on Ether7 (labeled PoE/Boot), 15-57 V passive PoE only. For alternative use only.
Maximum power consumption 34 W. With attachments 39 W.
Connecting to a POE Adapter:
Connect the Ethernet cable from the device Eth7 to the POE out port of the POE adapter.
Connect an Ethernet cable from your LAN to the POE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Resetting the device
In case you wish to return the device to its original configuration, you can use the RESET button. Hold this button during boot time until LED lights start
flashing, then release the button to reset RouterOS configuration. You can use this procedure if you have forgotten the password to access the device, or
simply wish to return the unit to its default configuration state.
Extension Slots and Ports
MicroSD card slot.
MicroUSB type AB.
1x SFP cage in the combo group with 1x 10/100/1000 Ethernet port (software selectable which one will be active).
7x 10/100/1000 Ethernet ports.
RS232 serial console port (115200bit/s, 8 data bits, 1 stop bit, no parity).
1x SFP+ cage.
Two cooling fans.
Smart card slot.
Configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
