EasyManuals Logo
Home>MikroTik>Wireless Access Point>LHG 5 Series

MikroTik LHG 5 Series User Manual

MikroTik LHG 5 Series
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This device and its
antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
20 cm minimum distance has to be maintained between the antenna and the user. Under such
configuration, the FCC radiation exposure limits set forth for a population/uncontrolled environment
can be satisfied.
Antenna Installation. WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in the United States (or where FCC rules apply); only those antennas certified with
the product are used. The use of any antenna other than those certified with the product is expressly
forbidden in accordance with FCC rules CFR47 part 15.204. The installer should configure the output
power level of antennas, according to country regulations and per antenna type. Professional
installation is required for equipment with connectors to ensure compliance with health and safety
issues.
Innovation, Science and Economic Development
Canada
Model FCC ID
RBLHG-5HPnD-
XL
7442A-
LHG5ACD2HPD
This device complies with Industry Canada's license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MikroTik LHG 5 Series and is the answer not in the manual?

MikroTik LHG 5 Series Specifications

General IconGeneral
BrandMikroTik
ModelLHG 5 Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals