62
Pellerin Milnor Corporation
Figure 10. Shim Adjustment Steps
Steps
S1..Add shims to make the latch looser. Remove shims to make latch tighter. To add shims, add a notch to the shims
as shown. Then you will not have to remove the handle assembly. When you remove or add shims, always start
with the thinnest shim.
S2..Make a notch as shown.
S3..Put in the machine screw. Put the eye of the torsion spring on the screw then put the flat washer, lock washer, and
nut on the screw to hold the eye. Tighten the nut.
S4..Put the free end of the spring into this hole.
Legend
P...The shim with the added notch
Q...Rear view
R...Inside view
S...Detailed view
T...Torsion spring
U...The shim thickness is (.230 inches)
V...The shim thickness is (.015)
Door Handle and Lock Actuator
3 Sheets
Door Assemblies
To Next Page
Loading...
Need help?
General
