Pellerin Milnor Corporation 49
Legend
A—A.Cross section view of bearing
B—B.Rear view of bearing
C—C.Detailed view of vent
D—D.Detailed view of leak-off from seals
E...Apply adhesive to the bolt (not shown).
F...The seal holder must be fully down before you tight-
en the fasteners.
G...Apply primer and adhesive to the rear bearing cup
and holder housing.
H...Clean the shaft and inner sleeve. Make sure that they
are clean and free from oil. Apply adhesive to the
shaft, then apply the sleeve. Make sure of a bond on
a minimum of 75% of the surface.
J...Pack grease between these two seals during
assembly.
K...Item 15 is not shown. These plugs are used tempora-
rily to prevent dirt from entering unfilled holes.
L...8 instances
M...As needed
Main Bearing
3 Sheets
30015V8Z,VZZ and 30022V8Z,VZZ
BPWOAB05 / 2019404
BPWOAB05.1 0000254615 B.2 C.3 1/2/20 2:25 PM Released
Cylinder, Shell and Bearing Assemblies
To Next Page
Loading...
Need help?
General
