7-1
7 Upgrade
7.1 Introduction
You can upgrade parameter modules, functional assemblies and software by connecting the
patient monitor to a PC running the System Update Tool.
NOTE
z If you have to disassemble the patient monitor for software upgrade, be sure to
eliminate the static charges before disassembling the equipment. When
disassembling the part labeled with a ESD warning symbol, make sure you are
wearing electrostatic discharge protection such as antistatic wristband or gloves to
avoid damaging the equipment.
z Properly connect and route the cables and wires when reassembling the equipment
to avoid short circuit.
z Select appropriate screws to assemble the equipment. If unfit screws are tightened
by force, the equipment may be damaged and the screws or part may fall off
during use, causing unpredictable equipment damage or human injury.
z Follow correct sequence to disassembly the equipment. Otherwise, the equipment
may be damaged permanently.
z Disconnect all the cables before disassembling any parts. Be careful not to damage
any cables or connectors.
z Properly place removed screws and disassembled parts, preventing them from
being lost or contaminated.
To Next Page
Loading...
Need help?
General
