1
Product Overview
Front View
1. Power On/Off Switch
Press the switch to turn on the patient monitor. When the monitor is
on, pressing and holding this switch turns the patient monitor off. An
indicator is built in this switch. It turns on when the patient monitor is
on and turns off when the patient monitor is off.
2. AC power LED
It turns on when AC power is connected.
3. Battery LED
On: when the battery is installed and the AC source is connected.
Off: when no battery is installed or the installed battery is malfunction,
or no AC source is connected when the patient monitor is power
off.
Flash: when the patient monitor operates on battery power.
4. Alarm lamp
When a physiological alarm or technical alarm occurs, this lamp will
ash as dened below.
the lamp quickly ashes red.
the lamp slowly ashes yellow.
the lamp lights yellow without ashing.
5. Display Screen
6. Press to silence all alarm sounds.
7. Press to pause or restore alarms.
8. Press to freeze or unfreeze waveforms.
9. Knob
10. If no menu is displayed on the screen, pressing it enters the
main menu.
If there is a menu displayed on the screen, pressing it closes that
menu.
11. Press to start or stop recordings.
12. Press to start or stop NIBP measurements.
High level alarms:
Meidum level alarms:
Low level alarms:
6
7
8
9
10
11
12
1
2
3
5
4
To Next Page
Loading...
Need help?
General
