25
CONTENTS
DISCLAIMER
The Minelab metal detector described in this instruction manual has
been expressly designed and manufactured as a quality metal detector
and is recommended for treasure and gold detecting in non-hazardous
environments. This metal detector has not been designed for use as a
landmine detector or as a live munitions detection tool.
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Minelab is under license.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its
subsidiaries. Qualcomm is a trademark of Qualcomm Incorporated,
registered in the United States and other countries. aptX is a trademark of
Qualcomm Technologies International, Ltd., registered in the United States
and other countries.
MINELAB®, GPX 6000™, GeoSense-PI™, GPX 11™, GPX 14™, and GPX 17™ are
trademarks of Minelab Electronics Pty. Ltd.
This work is licensed under the Creative Commons Attribution-
NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0)
International License. To view a copy of this license, visit:
http://creativecommons.org/licenses/by-nc-nd/4.0/
Care and Safety
Operate and maintain your detector following the below recommendations to ensure
its safe use and long life.
` Do not submerge the detector body in water — it is rain-proof only.
` All GPX 6000™ coils are waterproof to 1 metre (3.3 feet), however care must be taken to ensure the coil connector
is not submerged.
` The battery pack is not waterproof — Do not immerse the battery pack in any liquid or allow water ingress.
` Wash your hands before handling the detector after applying sunscreen or insect repellents.
` Do not use solvents to clean. Use a damp cloth with a mild soap detergent.
` Never allow the detector to come into contact with gasoline/petrol or other petroleum-based liquids.
` Avoid getting sand and grit in the shafts and fastenings (e.g. coil yoke assembly and twist locks). If sand and grit
accumulates in these parts they should be thoroughly rinsed and dried.
` Do not bring the detector or accessories into contact with sharp objects as this may cause scratches and damage.
` Do not leave the detector in excessive cold or heat longer than necessary. Covering it when not in use will help protect it.
Avoid leaving it in a hot vehicle.
` Ensure the coil cable is in good condition and not subject to undue stress.
` Take precautions when transporting or storing the detector. Although the detector is constructed from the highest
quality materials and has undergone rigorous durability tests, the detector parts and display screen could become
scratched or seriously damaged if not treated with due care.
` Do not expose the ML 100 headphones or charging accessories to liquid/moisture or excessive humidity.
` Do not allow children to play with the detector or included accessories — small parts can be a choking hazard.
` Only charge rechargeable batteries and accessories according to the instructions provided.
` Avoid charging rechargeable batteries and accessories in extreme temperature conditions.
` Remove battery prior to air transportation.
To Next Page
Loading...
Need help?
General
