12 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
COPILOT
• When the Momentary/Constant Switch is in the MOM position, the operator may begin using the remote at any time.
• As soon as any remote button is pressed, the initial speed setting will be set to approximately the same value as the Speed Control
value on the Foot Pedal. The prop will not automatically turn on until the Prop ON/OFF button on the remote is pressed.
• Pressing the Momentary Button on the Foot Pedal or adjusting the Speed Control dial will override the remote and receiver
function. Control of the motor will automatically go to the Foot Pedal. The prop speed will also revert to the current value of the
Speed Control dial on the Foot Pedal.
Operating without the Foot Pedal
• If the foot pedal is not being used, the CoPilot receiver will always react to any commands from the CoPilot remote.
AUDIO MODES
There are three receiver Audio Modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to another,
simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
Audio Pattern What Condition Causes Audio Pattern Audio Mode
1 Beep Pressing the Increase Speed or Decrease Speed button Modes 2 and 3
1 Beep Pressing the Prop ON/OFF button to turn the Prop on Modes 2 and 3
2 Beeps Pressing the Prop ON/OFF button to turn the Prop off Modes 2 and 3
Single tick every 1.5 seconds When the Prop is active including when Speed Control dial is set to 0 Mode 3
1 Beep Switching to audio Mode 1 All
2 Beeps Switching to audio Mode 2 All
3 Beeps Switching to audio Mode 3 All
1 Chirp Every time the receiver is powered up and there is at least one remote learned All
2 second long Beep Every time the receiver is powered up and there are no remotes learned All
5 Beeps Speed Control dial on Foot Pedal (if applicable) is moved after speed has been adjusted with remote All
Steady Tone Heard while holding down the Learn button on the receiver All
4 Beeps Heard after a remote button is pressed while the receiver learns it. All
Ten second warbling sound that
transitions into a steady tone
Heard during the process used to clear all stored remote. after the learn switch is released, a 2 second long
beep will be heard
All
1 long Beep, 2 short Beeps, pause
(repeat)
Powered up with Momentary/Constant Switch in the CON position (or the Momentary Button held) when the
Foot Pedal (if applicable) is moved to momentary, the power up audio will be heard
All
NOTICE: When the Foot Pedal (if applicable) is operating the motor and the propeller is on, the prop on indicator tick will be
heard if the receiver is set to Audio Mode 3.
Audio Mode Function
Mode 1 All of the normal audible sounds mentioned in this owners manual, but no audible beeps for speed increase/ decrease or prop on/off.
Mode 2 Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off.
Mode 3 Same as audio mode 2 plus the prop on audible tick every 1.5 seconds.
To Next Page
Loading...
Need help?
General
