EasyManuals Logo
Home>Mitsubishi>Projector>HC3800

Mitsubishi HC3800 User Manual

Mitsubishi HC3800
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
EN-6
2
3
1
What’s included in the box
AC power cord
1 RGB cable for PC
for US J2552-0063-03
for EU J2552-0066-02
for UK J2552-0065-02
J2552-0072-03
1 Remote control
1 User Manual/Quick Start up (English only)
1 Safety Manual/Quick Start up
1 CD-ROM (with User Manual)
2 Battery
1 Lens cap
1 Lamp replacement attachment
Important:
The attached power cords are to be used exclusively for this product. Never use them for other products.
Inserting the batteries into the remote control
Remove the back lid of the remote control.
Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
If the battery is inserted from the (+) side first, inserting
the (-) side is difficult because the coil spring end hits
on the battery side. If the battery is forced in this way,
the outer label of the battery may get ripped and it may
cause a short-circuit and heating.
Attach the back lid.
Important:
Use two size-AA batteries (R6).
Replace the two batteries with new ones when the
remote control is slow to respond.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the batteries.
Caution:
Use of a battery of wrong type may cause explosion.
Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
Dispose of used batteries according to your local regulations.
Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.
Be sure to handle the batteries according to the instructions.
Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
Keep batteries out of reach of children and pets.
Remove the batteries, if the remote control is not used for a long time.
Do not combine a new battery with an old one.
If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in
contact with your eyes, rinse them with water and then consult your doctor.
1.
2.
3.
Preparing your projector

Other manuals for Mitsubishi HC3800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi HC3800 and is the answer not in the manual?

Mitsubishi HC3800 Specifications

General IconGeneral
Native aspect ratio-
Projection distance- m
Vertical scan range50 - 85 Hz
Horizontal scan range15 - 80 kHz
Projection technologyDLP
Supported aspect ratios4:3, 16:9
Contrast ratio (typical)4000:1
Screen size compatibility50 - 300 \
Projector native resolution1080p (1920x1080)
Keystone correction, vertical-15 - 15 °
FocusManual
Focal length range20.6 - 30.1 mm
Lamp power230 W
Light source typeLamp
Lamp power (economic mode)190 W
Service life of light source5000 h
Noise level31 dB
Plug and PlayYes
Dot clock scanning frequency170 MHz
Supported video modes1080i, 1080p, 480i, 480p, 576i, 576p, 720p
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Built-in speaker(s)No
Audio (L/R) in2
Serial interface typeRS-232
USB 2.0 ports quantity0
S-Video inputs quantity1
Power sourceAC
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)340 W
PlacementDesktop
Product typeStandard throw projector
Product colorBlack
Weight and Dimensions IconWeight and Dimensions
Depth270 mm
Width345 mm
Height129 mm
Weight3500 g

Related product manuals