Mitsubishi HC3800 User Manual

EN-9
Using the remote control
Operational range of the remote control
Keep the remote control photo-sensor out of direct
sunlight or fluorescent lamp light.
Keep the remote control photo-sensor at least 2 m (6
feet) away from fluorescent lamps. Otherwise, the remote
control may malfunction.
If there is an inverter-operated fluorescent lamp near the
remote control, the remote control operation may become
unstable.
When you use the remote control too close to the remote
control sensor, the remote control may not work correctly.
When operating the remote control, keep the distance
from the remote control to the projector via the screen
within about 5 m (15 feet). The operable range of the
remote control, however, depends on the characteristics
of the screen.
Reception angle
Vertical directions
20°
10°
20°
10˚
Vertical directions (ceiling mount)
20°
20°
•
•
•
•
30°30°
Operate the remote control within a distance of
10 m (30 feet) from the projector, pointing the IR
beam at the remote control photo-sensor (front
or rear) of the projector.
Front of projector Rear of projector
30°30°
30°30°
Operate the remote control within a distance of
10 m (30 feet) from the projector, pointing the IR
beam at the remote control photo-sensor (front
or rear) of the projector.
Front of projector Rear of projector
30°30°

Mitsubishi HC3800 Specifications

General

Native aspect ratio	-
Projection distance	- m
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	DLP
Supported aspect ratios	4:3, 16:9
Contrast ratio (typical)	4000:1
Screen size compatibility	50 - 300 \
Projector native resolution	1080p (1920x1080)
Keystone correction, vertical	-15 - 15 °
Focus	Manual
Focal length range	20.6 - 30.1 mm
Lamp power	230 W
Light source type	Lamp
Lamp power (economic mode)	190 W
Service life of light source	5000 h
Noise level	31 dB
Plug and Play	Yes
Dot clock scanning frequency	170 MHz
Supported video modes	1080i, 1080p, 480i, 480p, 576i, 576p, 720p
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Built-in speaker(s)	No
Audio (L/R) in	2
Serial interface type	RS-232
USB 2.0 ports quantity	0
S-Video inputs quantity	1
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	340 W
Placement	Desktop
Product type	Standard throw projector
Product color	Black

Weight and Dimensions

Depth	270 mm
Width	345 mm
Height	129 mm
Weight	3500 g