WHEEL AND TIRE
TSB Revision
WHEEL AND TIRE
31-45
NOTE: .
It may take approximately one minute that the data of
tire pressure change is displayed on the scan tool
MB991958 screen.
If the data of tire pressure change is not displayed on
the scan tool MB991958 screen, the most possible
cause is that the radio wave sent from the TPMS
transmitter cannot be received. In this case, the radio
wave may be received by performing the procedures
from (1) again after turning the tire to change the
TPMS transmitter position. If the tire pressure change
is still not displayed on the scan tool MB991958
screen, the TPMS transmitter in which the ID code is
not registered may be installed, or the TPMS transmit
-
ter may be faulty. Therefore, perform ID code registra-
tion or replace the TPMS transmitter according to the
instructions of troubleshooting for DTCs. (At this time,
do not register the ID codes or replace the TPMS
transmitter.)
3. Check the tire pressure or acceleration value shown in the
screen (if needed).
4. After checking by the tire pressure change, adjust the
checked tire pressure to the proper value.
WHEEL AND TIRE
INSTALLATION SERVICE POINT
M1311001300647
Tighten the wheel nuts to the specified torque.
Tightening torque: 98 10 Nm (72 7 ft-lb)
To Next Page
Loading...
Need help?
General
