EasyManuals Logo
Home>Mitsubishi>Automobile>MONTERO

Mitsubishi MONTERO User Manual

Mitsubishi MONTERO
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
ABS <4WD> -
Troubleshooting
35B-19
Inspection procedure 2
Communication with MUT-
II
and the ABS-ECU is not
possible.
Probable cause
The cause is probably an open circuit in the ABS-ECU power supply circuit or
an open circuit in the diagnosis output circuit.
D
Blown fuse
D
Malfunction of harness or connector
D
Malfunction of the ABS-ECU
(1)NG
OK
Check the following connectors:
E-13, E-107
NG
Repair
OK
Check the trouble symptoms.
NG
Check the harness wire, and repair if necessary.
D
Between ABS-ECU and diagnosis connector
OK
Check the following connectors:
D-32 <R.H.D.>, D-128,
D-208, D-210 <R.H.D.>, D-213 <L.H.D.>, E-08 <Diesel>, E-13,
E-106
NG
Repair
OK
Check the trouble symptoms.
NG
Check the harness wire, and repair if necessary.
D
Between the ignition switch and the ABS-ECU
NG
Repair
OK
Check the trouble symptoms.
NG
Check the harness, and repair if necessary.
D
Between the ignition switch and the ABS-ECU
OK
NG
Repair
OK
NG
Replace the ABS-ECU.
Measure at diagnosis connector D-23 and ABS-ECU connector
E-107.
D
Disconnect the connectors and measure at the harness
side.
D
Continuity between the following terminals:
Between terminals 47 (ABS-ECU side) and 1 (diagnosis
connector side)
Between terminals 36 (ABS-ECU side) and 7 (diagnosis
connector side)
OK:
Continuity
NG
Check the following connectors:
D-23, D-33, D-128, D-222,
E-13, E-107
Check the trouble
symptoms.
Check the following connectors:
E-106, E-107
(2)NG
Measure at ABS-ECU connectors E-106, E-107.
D
Disconnect the connectors and measure at the harness
side.
D
Ignition switch: ON
(1) Voltage between terminal 13 and body earth
OK:
System voltage
(2) Voltage between terminal 31 and body earth
OK:
System voltage
OK
Check the following connectors:
E-106, E-107
Repair
OK
Check the trouble
symptoms.
NG
Check the harness wire, and repair if necessary.
D
Between the ABS-ECU and earth
NG
NG
Measure at ABS-ECU connectors E-106, E-107.
D
Disconnect the connectors and measure at the harness
side.
D
Continuity between terminals 12, 25, 26 and 42 and body
earth
OK:
Continuity
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi MONTERO and is the answer not in the manual?

Mitsubishi MONTERO Specifications

General IconGeneral
BrandMitsubishi
ModelMONTERO
CategoryAutomobile
LanguageEnglish

Related product manuals