Mitsubishi MT180D Instruction Book

3. The element may be washed in synthetic detergent.
After washing, rinse the element completely and
dry before mounting. Never use it before drying up
completely.
4. Be careful not to allow the dust in the body ass'y and
on the pressure-fitted surface of the element seal to
enter the air hose. Disconnect the air hose when
cleaning the cleaner body by blowing the air.
Assembling
the element
Assemble the element to the body and fasten with the wing
bolt completely. Assemble the separator plate ass'y to the
dust pan ass'y and install it to the body ass'y taking care of
the top mark.
NOTE
1. When
operating in extremely dusty conditions,
service the filter more frequently than specified.
2. Clean
the element with compressed air below
7 kg!cm
2
(100 psi).
FAN BELT TENSION ADJUSTMENT
-31-
Proper fan belt tension is for 1 0 ~ 12 mm (0.4 - 0.5 in.)
deflection with a thumb pressure applied halfway between
the crank pulley and alternator pulley. To adjust the ten·
sion, loosen the alternator bracket bolt and the adjust
plate bolt and move the alternator in or out. After proper
tension is obtained, tighten the bolt securely. Check the
belt for cracks and damages.
BATTERY
(OUTSIDE NORTH AMERICA)
The battery equipped is POL YM ION battery, model
NX100-S6L (S). Though small-sized, it shows 40% higher
perfromance as compared with conventional batteries of
the same size_
1.
The specific gravity of electrolyte is 1,280 ± 0.010
at 20°C (68°F).
NOTE
Shipment for North America does not contain battery.
Read battery manufacturer's manual and follow.
ACAUTION
When the battery is not used for a long period of time
in cold weather, check the specific gravity and charge
the battery periodically.
2. The level of electrolyte should be between the lower
and upper levels indicated on the outside of the battery
case. Particularly in hot weather, frequently check
the level of battery electrolyte.
3. I n order to prevent the development of rust or other
corrosion at the battery terminal, coat the terminal
lightly with lubricant.
4. Before demounting the battery, be sure to shut down
the engine and turn off all the electrical switches.
Battery cable at earthing end (negative terminal end)
should be disconnected first.
5.
For cleaning the terminal stud, first remove the battery
cable then use a wire brush for brightening it.
6. For the reinstallation of the battery, make sure to set it
on the battery support properly.
7. For connecting the battery cables, connect ® end of it
first,
followed by earthing end.
ACAUTION
The electrical system is of negative earth type. Care
should be taken to ensure that the battery terminals
are correctly connected when installing the battery.
8. For dependable battery service, see your local dealer.

Mitsubishi MT180D Specifications

General

Brand	Mitsubishi
Model	MT180D
Category	Tractor
Language	English