15
6. PROPER SEWING
6-1. Operation of the halt switch
If an incident such as a thread breakage, needle breakage and any other incidents are
happened during the sewing operation, please hit immediately the halt switch. The sewing
machine running is stopped instantly.
(1) Press the HALT switch (NO.1), All operations will stop, and the sewing machine will stop
at the needle UP state without trimming the thread.
(2) Remove the cause of the abnormality.
(3) To continue sewing, turn the HALT switch to the right.
The switch will be unlocked.
Next, when the start switch (NO.3) (gray foot switch) is pressed again, the operation will
resume from the halted position.
(4) To cancel sewing, turn the HALT switch (NO.1) to the right, and unlock the switch.
Then, press the key on the operation panel (NO.2).
The work holder (NO.4) will return to the home position from the stopped position and will
stop.
Before start the sewing operation, please make sure the location of the halt switch and
keep it in mind the function and how to use it.
To Next Page
Loading...
Need help?
General
