Mitsubishi RCN-EK2 User Manual

-
11
-
❚
11. CHECK INDICATION
If the following LED blinks or any code appears on the monitor display, it indicates that an error has occurred in the air
conditioner. Please contact your dealer and inform them “address No. and check code”, “symptom of the trouble”, “air
conditioner type” and “model name” etc. Press the ON/OFF button to stay the air conditioner on the stop mode.
■
Ceiling suspended (FDE)
CHECK MODE INDICATOR TIMER/CHECK LED
■
Ceiling cassette -4 way- (FDT)
■
Ceiling cassette -4 way Compact- (FDTC)
■
Ceiling cassette -1 way- (FDTS)
TIMER
CHECK RUN
CHECK MODE INDICATOR TIMER/CHECK LED
For FDE, FDT, FDTC, or FDTS
•
The TIMER/CHECK LED blinks (stays on for 0.5
seconds and shuts off for 0.5 seconds), and the air
conditioner stops simultaneously.
•
Address No. is displayed on the CHECK MODE
INDICATOR, check code display after address No.
turns off.
•
The monitor display turns off when the display time
lapses.
•
If no codes are displayed on the monitor, operate the
remote control or press the BACK UP switch.
■
RCN-KIT4-E2
Address No. Error code
CHECK MODE
For RCN-KIT4-E2
•
The RUN/CHECK LED blinks (stays on for 0.5 seconds
and shuts off for 0.5 seconds), and the air conditioner
stops simultaneously.
•
Address No. and check code are displayed on the
check mode indicator.
•
The monitor display turns off when the display time
lapses.
•
If no codes are displayed on the monitor, operate the
remote control or press the BACK UP switch.
■
Ceiling cassette -2 way- (FDTW)
CHECK1
CHECK2 TIMER/CHECK RUN
CHECK1 LED
TIMER/CHECK LEDCHECK2 LED
■
Floor standing -2way- (FDFW)
TIMER/CHECK LED
CHECK1 LED
CHECK2 LED
For FDTW, FDFW
•
The TIMER/CHECK LED blinks (stays on for 0.5
seconds and shuts off for 0.5 seconds), and the air
conditioner stops simultaneously.
•
Only the number that corresponds to the “tens place” or
“ones place” of the error code on the “CHECK 1” or
“CHECK 2” indicator LED blinks (10 seconds per cycle).
•
To indicate an error code, the LED blinks as shown
below.
Example: For E39
ON OFF
0.5 s 0.5 s
0.5 s 0.5 s
CHECK1 LED
10 sec. per cycle
CHECK2 LED
■
Wall mounted (FDK)
~56 71~
RUN/CHECK1 LED
TIMER/CHECK2 LED
For FDK
•
Only the number that corresponds to the “tens place” or
“ones place” of the error code on the RUN/CHECK1
LED or TIMER/CHECK2 LED blinks (10 seconds per
cycle), and the air conditioner stops simultaneously.
•
To indicate an error code, the LED blinks as shown
below.
Example: For E39
ON OFF
0.5 s 0.5 s
0.5 s 0.5 s
RUN/CHECK1
LED
10 sec. per cycle
TIMER/CHECK2
LED
PJZ012A128_EN.indd 11PJZ012A128_EN.indd 11 11/10/2016 6:53:23 PM11/10/2016 6:53:23 PM

Mitsubishi RCN-EK2 Specifications

General

Brand	Mitsubishi
Model	RCN-EK2
Category	Remote Control
Language	English